1998 Sea-Doo Sportster 1800 single carb 717 Motors. The motor started fluctuating at times at wot. If I blip the throttle it would go away. Then for whatever reason when I was turning left it would start to get worse. I rebuilt the carburetor. Carb bath, compressed air, blew out everything I could every which way possible. I did put in a new needle and seat. I reused the stock spring. I did not have time to check the pop off. Got it fired and ran but then didn't want to keep running especially over 3000 RPM in the water. When it did run it would cut out directly after when I try to throttle up. It kept dying out...If i played w the throttle, under way using the other motor, I could keep it running @ about 2500 rpm for a bit but it would eventually die
Announcement
Collapse
No announcement yet.
Help! Carb issues / rebuild
Collapse
X
-
OK, the next question is, when using the Mikuni Brand Rebuild kits. IF you used either of the springs, it will make your pop-off way to high. We see this all the time anymore. Hope this helps, your Pop-Off should be under 25 pounds!! Hope this helps you.
Comment
-
Because I was trying to cheat and not check the pressure I use the existing spring. I’m going to check the pop off on the machine I know I have to block off the return but that’s OK. Can can I test The fuel pump pressure to the carburetor while it’s running? If so what should the pressure be runningLast edited by 123indyrt; 07-30-2018, 09:00 PM.
-
Comment