Milling And Redesigning Cylinder Heads
(Two-Stroke Application)
In the past 11 years we have been using Sea-Doo based
machines for our customers "SPEED-NEEDS" and have
found after extensive Competition Usage, and the best
of Grudge-Racing alike, our Milled and Redesigned
heads are Easily up too the task. DO NOT fall prey
to those that would have you believe that your Rotax
Power-Plant needs any additional cooling at the Cylinder
Head area!! They are WAY more than JUST OK, even,
we prefer them!! Extensive Dyno and On-Board Computer
Telemetry has proven that we are correct on this as
does our long record of a failure rate well under
1%......we'll accept that! Virtually none!! (Including
PRO SS UNITS) Let us design the Cylinder head for
your needs. Unlock some of the explosive-acceleration
that a higher compression ratio yields! You will need
91-93 Octane Fuel for our most effective Set-Ups,
and Race Fuel when required!! Perry Performance Group,
your Cylinder Head, Head-Quarters!!
)
)
)
)
)
)
